Bioelectrical impedance analysis (or BIA) is a simple and non-invasive test measuring how low-voltage electric currents circulate through the body with the help of electrodes.
Because BIA helps to distinguish how body fat, muscles, and body water are distributed in your body tissues, it is widely used to determine your body composition.
When there is too much fat in relation to lean body mass, it is known as “altered body composition.” While many people focus only on weight, altered body composition is known to increase one’s risk for a variety of diseases, including cardiovascular disease, type 2 diabetes, and hypertension.
Therefore, BIA can be a critical assessment of your health.
Here’s what you should know about the BIA method, history, accuracy and potential bias.
Bioelectrical impedance analysis (BIA), or bio-impedance, is the measurement of the resistance of biological tissues to the flow of a low-voltage current.
The human body is composed of different types of tissues, which have different levels of electrical conductivity. With a voltage around 70 microamperes (μA), the current will go mainly through the most conductive tissues, such as water or muscles.
By measuring the voltage drop between source and receiver electrodes, BIA determines the resistance level of these tissues to the passage of the current.
A four-electrode configuration for BIA between the right arm and right leg.
Called “impedance,” this resistance (Z) corresponds to the ratio of the voltage (V) measured between 2 points in contacts with the tissue, on the intensity (I) of the frequency to the current applied to this tissue.
The impedance calculation is then Z=V/I.
Although the first electrical impedance tests date back to Georg Simon Ohm (1788-1854), its application to the human body and the measurement of biological tissues was theorized in the second half of the 20th century.
In 1962, in a paper entitled “Bioelectric properties of tissue. Impedance measurement in clinical medicine. Significance of curves obtained,” the French physician Thomasset first introduced a method using two electrodes, comparing two current frequencies to allow any doctor to calculate lean body mass and obtain a satisfactory estimate of a patient’s nutritional status.
With time and a growing interest in body composition, other methods emerged. In 1994, the National Institutes of Health (NIH) agreed on a technology assessment, whose purpose was “to provide physicians with a responsible assessment of bioelectrical impedance analysis (BIA) technology for body composition measurement.”
Bioelectrical impedance analysis is now widely used in the medical field to distinguish the amount of body water, body fat and skeletal muscle in a body.
The analysis first obtains total body water (TBW). This is the amount of fluid that can be found inside and outside your body cells. For an adult, total body water represents 45 to 60% of total body weight.
The other components—with more insulating properties such as body fat or skin—will be more “resistant,” meaning that they conduct electricity less effectively.
Using ratios of bioelectrical impedance measured at a separate frequency, complex equations then estimate the amount of fat-free mass within the body. The amount of body fat is finally deducted from the total weight.
Note: Bioelectrical impedance is also a method used in cardiology to assess pulse wave velocity, another biomarker that determines the stiffness of the arteries to infer cardiovascular health.
The signal used in bioelectrical impedance analysis is totally safe and painless for both adults and children, but note that bioelectrical impedance is not recommended for people with pacemakers.
On one hand, many scientific publications attest to the reliability, precision and accuracy of the BIA method in providing valid estimates of total body water in individuals.
On the other hand, there is still a need for standardization and consensus on certain factors that may alter the test results. Some of these factors are described in a study published in The American Journal of Clinical Nutrition entitled “Clinical characteristics influencing bioelectrical impedance analysis measurements.”
Changes in the skin temperature due to the environment where the measurement is taken are thought to impact skin surface impedance, as detailed in a science paper published in the Journal of Applied Physiology: “Controlled ambient and skin temperatures should be included in the standardization of BIA measurements.”
Because muscles are largely composed of water, dehydration decreases the amount of fluids and electrolytes that might lower the conduction of these tissues. As a result, fat-free mass is more likely to be underestimated. Hydration levels vary widely throughout the day, which explains why consistency is an important factor in accurate BIA estimation.
A 2017 study published in the Journal of Bodywork and Movement Therapies, “Body composition estimation in children and adolescents by bioelectrical impedance analysis: A systematic review,” demonstrated a perfect correlation between BIA-based body composition estimation in children with reference methods. However, fat-free mass is still often underestimated in children.
Because the equations that interpret the fat-free mass based on total body water results rely on reference population segments, the body composition estimate might be inaccurate for people considered to be overfat. A study entitled “Evaluation of visceral fat in massive obesity” indicated that an “underestimation of fat mass in obese subjects, and the error becomes greater with increasing BMI.”
People wearing metal implants may experience an underestimated body fat reading. However, this reading will remain constant over time, so they can successfully track their changes in body composition.
Many devices have been designed to measure bioelectrical impedance with increased accuracy and convenience over the years. Using the same measurement method, they mainly differ in terms of the number of electrodes and which section of the body is being measured vs. which one is being estimated.
Beyond the design of these devices, what matters is also the nature and complexity of the algorithm performed to estimate total body water and fat-free mass based on the received frequencies. To build these algorithms, scientists use body fat standards that can vary.
Using smart scales to measure your body composition can help you reliably and cost-effectively track changes if the measurement remains at a consistent level.
These scales have the ability to send the electrical current up one leg and down the other leg. Before using, users must set their age, height, and sex.
Handled BIA devices
Also called hand-to-hand impedance devices, they measure arm and upper trunk bioimpedance.
Whole-body impedance devices
These common BIA devices are composed of four electrodes, each of which are placed on half of the body (left or right), sending a current from the arm through the body and down the leg.
The Direct Segmental Multi-Frequency BIA (or DSM-BIA) is the most advanced, and also the most expensive, device providing bioelectrical impedance analysis. This device divides the body into 5 segments and independently measures the impedance for each segment.
Bioelectrical impedance analysis (BIA) remains a quick and safe method for estimating body composition in adults. This is why this cost-effective alternative is widely used in clinics and in sports medicine and other health-related fields. Many research efforts are yet to agree on a standard that can help correct the remaining questions of interpretation bias when using the BIA method. However, consistency in measurements accurately helps to detect variations, which makes it easy for anyone to track changes in body composition.
The service Health+ unlocks an in-app health experience with access to daily engagement support and exclusive content in the areas of sleep, nutrition and activity. With Health+, you’ll get guided on a daily basis to create a healthy routine that sticks.
Promotional Offers of Health+ service bundled with a Body Scan health station
For the launch of the Body Scan health station, we offer two introductory subscription (1)(2) plans to the Health+ service:
The 3-month trial period starts on the product’s installation using the Withings mobile application.
(1) These introductory offers are not mandatory to use the Body Scan health station. By selecting one of these offers, you agree to conclude a subscription contract with Withings for the Health+ service with the terms and condition described below. The contract will start upon Body Scan health station installation using the Withings mobile application.
(2) Promotional or introductory offers: we may from time to time offer special promotional offers, plans or subscriptions. Offer eligibility is determined by Withings at its sole discretion and we reserve the right to stop making an offer. It is not possible to combine several promotional offers unless specifically mentioned.
(3) Offer reserved for new Health+ subscribers only (any person not subscribed to Health+ service during the last month). Right after the 3-month trial period, the monthly auto-renewal starts and you will be automatically charged 9.95€ (or $9.95 or £9.95) per month. You can unsubscribe at any time. See below for cancellation, termination and usage conditions.
(4) Offer reserved for new Health+ subscribers only (any person not subscribed to Health+ service during the last month). Right after the 3-month trial period, the annual auto-renewal starts and you will be automatically charged 99.5€ (or $99.5 or £99.5) per year. You can unsubscribe at any time. See below for cancellation, termination and usage conditions.
Terms and conditions for a Health+ subscription